Monitor Configuration; Call Tone Volume; Multifunction Button - Fermax KITS EVOLUTION AVISA Manual Instalador

Kits EVOLUTION
Kits EVOLUTION
MONITOR
CONFIGURATION
The monitor lets you configure and adjust the following parameters and options:
- Adjust Call Volumen.

- Multifunction Button.

- Ring Tone Selection.
- Change Master Code.
To configure the different monitor options and settings, it is necessary to use the monitor keypad to enter
the programming code, followed by a sequence of codes, depending on the setting or configuration to be
done.
Programming entry code: Master Code + AB
Each of the settings available is described in detail below:

Call Tone Volume

VOLUME LEVEL
LOW
HIGH
Once the volume level has been selected, you can hear the call tone by pressing the telephone hang up
button.
Multifunction Button
The function of this button is selectable from 3 possible options:
* Activation of the 5th monodecoder relay (auxiliary device): The Relay is
activated by pressing the «F» button on the monitor.
* Panic Call: Sends a panic alert (emergency call) to a panic guard unit (if
there is a guard unit).
* Connection to Alarms Reception Centre.
BUTTON FUNCTION
RELAY ACTIVATION (AUX. DEVICE)
PANIC CALL
ALARMS RECEPTION CENTRE
Pag 30
KEY SEQUENCE
Master Code + AB + 6+0
Master Code + AB + 6+1
KEY SEQUENCE
Master Code + AB + 7+0
Master Code + AB + 7+1
Master Code + AB + 7+2
EXAMPLE
1234AB60
1234AB61
HANG UP
BUTTON
1
1 2 3
F
4 5 6
7 8 9
0 #
*
A B C
EXAMPLE
1234AB70
1234AB71
1234AB72
F E R M A X
RED LED