Preparing The Pressure Washer For Operation; Assembling The Pressure Washer - Stihl RE 90 Manual De Instrucciones

English
Angled spray lance and angled nozzle
WARNING
￭ An angled spray lance and the angled nozzle intensify the
lateral reactive forces. The reactive forces occurring may
cause the user to lose control of the spray attachment.
The user may be seriously injured and property may be
damaged.
► Attach only one spray lance extension.
► Hold the spray gun firmly with both hands.
6 Preparing the pressure washer for
operation
6.1

Preparing the pressure washer for operation

The following steps must be carried out every time before
starting work:
► Make sure that the pressure washer, the high-pressure
hose, the hose coupling and the connecting cord are in a
safe condition, @ 4.6.
► Clean the pressure washer, @ 15.
► If using a water filter and the water filter is dirty: Clean the
water filter, @ 15.4.
► Place the pressure washer on a stable, flat surface so that
it cannot slip or topple over.
► Connect the high-pressure hose, @ 7.2.1.
► Attach the spray gun, @ 7.3.1.
► Attach the spray lance, @ 7.4.1.
► Attach the nozzle, @ 7.5.1.
► If using a detergent: Using detergents, @ 11.4.
► If using an accessory: Fit accessory, @ 5.
► Connect the pressure washer to a water source, @ 8.
► Connect the pressure washer to the power supply, @ 9.1.
► If it is not possible to carry out these steps: Do not use the
pressure washer. Consult a STIHL servicing dealer.
50
6 Preparing the pressure washer for operation

7 Assembling the pressure washer

7.1 Assembling the pressure washer
Installing the holder
3
1
► Slide the holder (1) into the guides (2).
The holder (1) engages audibly.
► Push the plugs (3) into the mounts.
The plugs (3) engage audibly.
Attaching the handle and inserting the cleaning pin
4
2
3
► Slide handle (1) onto the holder (2).
► Insert screws (3) and tighten.
► Insert cleaning pin (4).
2
3
1
0458-814-8721-A