Adding Detergent; Tips For Operation - Stihl RE 109 Manual De Instrucciones

English
Standby mode
NOTICE
The machine must not be operated in
standby mode for more than 5 minutes.
Switch off the machine at the master
switch,
if work is interrupted for more than
–
5 min,
during breaks,
–
if the machine is left unattended.
–
High-pressure hose
NOTICE
Do not buckle or loop the high-pressure
hose.
Do not place any heavy objects on the
high-pressure hose, and do not drive
any vehicles over it.
48

Adding detergent

Remove nozzle from spray lance –
N
see "Fitting, removing spray lance"
3
Fill the container (1) with detergent
N
diluted as directed (approx.
0.5 liters).
Seal the container (1) and
N
nozzle (2)
Engage the container with nozzle
N
into the mount of the spray
lance (3). The nozzle has an anti-
twist device, orient this according to
the groove on the spray lance
RE 119 and RE 129 Plus only:
Use the adjusting ring (4) to set the
N
quantity of detergent to be added

Tips for operation

The following information and examples
of application make work easier and
contribute to achieving an optimum
cleaning result.
2
Operating pressure and water
4
throughput
1
High pressure dissolves dirt better. The
higher the water throughput, the easier it
is to remove the dirt that has been
loosened.
Clean delicate parts and surfaces (e. g.
car paint, rubber) by applying low
pressure or at a greater distance to
avoid damage. 100 bar pressure is
sufficient for cleaning vehicles.
Nozzles
Using the fan-jet nozzle
All-purpose – to clean parts and
(sensitive) surfaces.
The operating pressure can be infinitely
adjusted at the fan-jet nozzle.
RE 109, RE 119, RE 129 PLUS
+