After Finishing Work - Stihl RE 90 Manual De Instrucciones

12 After Finishing Work

3
4
► If a nozzle is attached to the spray lance (3): Remove the
nozzle
► Attach the spray set (4) to the spray lance (3).
► Soak extremely dirty surfaces with water before cleaning
them.
► Press the spray gun trigger and spray the detergent onto
the surface to be cleaned.
► Apply the detergent starting at the bottom and working up
and do not allow to dry.
► Remove the spray set.
► Attach the nozzle.
► Clean the surface.
12 After Finishing Work
12.1 After finishing work
► Switch off the pressure washer and pull the mains plug out
of the socket.
► If the pressure washer is connected to the water supply:
Turn off water tap.
► Press spray gun trigger.
The water pressure is reduced.
► Lock spray gun trigger.
► Disconnect pressure washer from the water supply.
► Remove water hose.
0458-814-8721-A
500 ml
400 ml
300 ml
200 ml
100 ml
► Remove high-pressure hose and let the remaining water
run out of the high-pressure hose.
► Remove and clean the nozzle and spray lance.
► Remove the spray gun and let the remaining water run out
of the spray gun.
► Clean the pressure washer.
7
6
► Roll up the high-pressure hose (1) and hang it on the
holder (2).
► Coil the connecting cord (3) on the holder (4).
► Secure the connecting cord (3) using the clip (5).
► Insert spraying set (6).
► Insert nozzle (7).
► Store the spray attachment in the holders (8) on the
pressure washer.
English
1
2
3
4
5
8
8
8
8
8
59