Working With Detergent; After Finishing Work; When Work Is Finished - Stihl RE 80.0 Manual De Instrucciones

Ocultar thumbs Ver también para RE 80.0:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 48
English
The fan-jet nozzle is adjustable.
Turning the fan-jet nozzle in the + direction
increases the working pressure.
Turning the fan-jet nozzle in the – direction
reduces the working pressure.
► Before starting work, direct the water jet at an
inconspicuous area of the surface and check
that the surface does not suffer damage.
► Select the distance between the nozzle and
the surface to be cleaned so that the surface
to be cleaned is not damaged.
► Adjust the fan-jet nozzle so that the surface to
be cleaned is not damaged.
► Move the spray attachment evenly along the
surface to be cleaned.
► Move forward slowly in a controlled manner.
10.4

Working with Detergent

Detergents can increase the cleaning effect of
the water. The use of the STIHL spraying set is
required for working with cleaning agents. The
STIHL spraying set may be included in the scope
of delivery, depending on the market.
► Dose and use cleaning agent as described in
the user manual for the cleaning agent.
40
► Fill the bottle (1) with maximum 500 ml of the
► Screw the spray nozzle (2) onto the bottle (1)
► If a nozzle is attached to the spray lance (3):
► Attach the spray set (4) to the spray lance (3).
► Soak extremely dirty surfaces with water
► Press the spray gun lever and spray the deter‐
► Apply the detergent starting at the bottom and
► Remove the spraying set.
► Attach the nozzle.
► Clean the surface.

11 After Finishing Work

11.1
► Switch off the high-pressure washer and pull
► If the high-pressure washer is connected to
► Press the spray gun trigger.
► Lock the spray gun trigger.
► Disconnect the high-pressure washer from the
► Remove the water hose.
► Remove the high-pressure hose and let the
► Remove and clean the nozzle and spray
► Remove the spray gun and let the rest of the
2
► Clean the high-pressure washer.
1
detergent.
and tighten firmly by hand.
4
Remove the nozzle.
before cleaning them.
gent onto the surface to be cleaned.
working up and do not allow to dry.

When Work is Finished

the mains plug out of the socket.
the water supply: Turn off water supply.
The water pressure is reduced.
water source.
rest of the water run out of the high-pressure
hose.
lance.
water run out of the spray gun.
11 After Finishing Work
3
0458-001-9821-B

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Re 80.0 x

Tabla de contenido