After Finishing Work; Preparing For Transportation Or Storage - Stihl RE 110 PLUS Manual De Instrucciones

13 After Finishing Work

► Rotate the fan-jet nozzle in the (+) direction to increase
the working pressure.
► Rotate the fan-jet nozzle in the (-) direction to reduce the
working pressure.
To clean:
► Before starting work, direct the water jet at an
inconspicuous area of the surface and check that the
surface is not damaged.
► Work at a distance that allows you to effectively clean the
surface without damaging it.
► Adjust the fan-jet nozzle and distance from the surface to
be cleaned to ensure the surface will not be damaged by
the spray.
► Move the spray attachment evenly along the surface to be
cleaned.
► Move forward slowly in a controlled manner.
0458-620-8621-A
13 After Finishing Work

13.1 Preparing for Transportation or Storage

To prepare the pressure washer for transportation or
storage:
► Switch off the pressure washer, @ 11.2.
► Disconnect the pressure washer from the power supply.
► Disconnect the pressure washer from the water supply.
► Press the spray gun trigger to relieve any remaining
pressure in the system.
► Lock the spray gun trigger.
► Disconnect the water hose.
► Remove and clean the nozzle and spray lance.
► Remove the spray gun and let the rest of the water run out
of the spray gun.
► If the pressure washer will be exposed to freezing
temperatures, protect it with antifreeze or take other
measures outlined below, @ 13.2.
► Clean the pressure washer.
► Insert the detergent spray set (1).
English
1
27