Korg SDD-3000 PEDAL Manual De Usuario página 10

To change the delay time past
the fine adjustment range, press
the FINE button so that the LED
turns off.
At this time, the value will
not change, even if the knob is
adjusted, until the knob is set
to match the current parameter
setting.
6. DELAY TYPE
1. SELECT button
Press this button to switch the
delay type.
SDD-3000: Created in 1982,
this effect is still popular with
guitarists and sound engineers
worldwide due to its distinctive
sonic characteristics. The sound
that continues to be loved remains
unchanged, but its usability has
increased dramatically.
ANALOG: This models an analog
delay using a bucket-brigade
device (BBD). It recreates the
degraded sound quality and
distortion that occurs in analog
circuits.
TAPE: This recreates the distortion
and rotational irregularities of
tape.
MODERN: Faithful to the
original sound, this is a delay
of clean tones.
KOSMIC: This delay is applied
by adding pitch changes to
reverberation. By adjusting
the parameter settings, various
effects can be obtained, from
a natural reverb to a string-
like sound or an eerie deep
and low resonating sound.
Increase the FREQUENCY in
10
5. SYNC LED
This indicates the method for
setting the delay time.
Simultaneously press the R
TIME and FINE buttons to
change the method for setting
the delay time.
SYNC on (LED lights up):
The delay time will be set as
the MODULATION section
to apply modulation to the
volume and obtain a more
fantastic effect.
REVERSE: This reverse delay
plays the delay sound in the
reverse direction.
PITCH: A pitch shifter is arranged
in front of the delay. Use the IN-
TENSITY knob in the MODULA-
TION section to set the variable
width of the pitch. If you want the
pitch variable amount to be fixed,
set the FREQUENCY knob to 0.
PANNING: This uses modulation
to control the orientation of the
delay output.
2. L/C/R button
On (LED lights up): This creates
a multi-tap delay that outputs to
the left, center and right.
The delay time and feedback
settings for the right channel
are disabled.
a note synchronized to the tap
tempo set with the TAP/BANK
DOWN foot switch.
See page 18 "Setting the delay
time as a note".
SYNC off (LED turns off): The
delay time will be set as time in
milliseconds.
Off (LED turns off): This
creates the normal stereo input/
stereo output delay.
Tip: If the delay type is set to
PANNING, the L/C/R button
functions as described below.
On (LED lights up): Panning
is normally centered on the
center.
Off (LED turns off): The
panning range is normally on
the left. With the FREQUENCY
knob set to 0, the INTENSITY
knob can directly control the
orientation.
1. SELECT button
2. L/C/R button