Korg SDD-3000 PEDAL Manual De Usuario página 27

4.
Press the WRITE button to send the dump data.
While sending data, the TIME/VALUE display will blink.
When the Bulk Dump function is selected, the MIDI THRU setting will be canceled, even
if the MIDI OUT/THRU function is set to thru.
Press the MIDI/SYS button again to return to the normal operating mode.
Restoring data
Dump data can be received from the external MIDI device where the SDD-3000 PEDAL dump
data was saved.
Note: For more details, refer to the owner's manual for the external MIDI device that will send
the dump data.
While receiving data, do not touch any of the device's buttons. In addition, do not turn off the
device.
1.
Connect a MIDI cable to the MIDI IN jack of the SDD-3000 PEDAL and to the MIDI OUT
jack of the device that will send the dump data.
2.
Make sure that the SDD-3000 PEDAL and the MIDI device sending data are set to the same
the MIDI channel.
If the SDD-3000 PEDAL will be receiving data that it previously sent to the external MIDI
device, select the same MIDI channel that was used when sending.
3.
Send the dump data from the connected MIDI device.
The SDD-3000 PEDAL will receive the data.
Dump current program data: Select the destination bank and program where it will be saved.
Dump all program data, Dump all data: All data will be automatically overwritten.
However, data being edited (edit buffer) will not be changed.
Dump global data: All data will be automatically overwritten.
When reception of the dump data is completed, "CpLt" appears on the TIME/VALUE display.
If an error has occurred, "Err" appears on the TIME/VALUE display. In this case, try sending
the data again.
27