OHAUS HOHTDG Manual De Instrucciones página 6

c P - Ht l H
ontrol anel ySing
The front panel of the HT Lysing Homogenizer contains all the controls and displays
needed to operate the unit
A. Power Switch: This is the main switch for the system. The unit will not function
unless this switch is in the on position. Switch to the on (-) position to power the unit.
Switch to the off position (o) to remove power from the internal electronic components
B. Standby button/standby indicator light: The standby indicator light will illuminate
when the main power switch is in the ON position. Press the standby button to take
the unit out of "Standby Mode". The standby indicator light will shut off. Press the
standby button again and the unit will once again be in standby mode.
C. Speed display: Displays the speed of the homogenizer D. Up/down arrows: For
set-point control. ON/OFF button starts/stops reciprocal motion function.
5
C.
D.
omogenizer
G.
E. Time Display: Displays the set time (before the unit is started) or remaining time
(once unit is running or if the unit is paused). The display range is from 00:00 to 10:00
minutes in 1 second increments. The display indicates minutes and seconds. This
unit can be only be used in timed (countdown) mode only.
F. Up/Down Buttons: For Set-point control Up/Down Arrows for set point control.
G. Program Buttons: Factory set buttons for common time and speed combinations
based on sample type. See page 7 for details. When a preset button is active, the
corresponding settings cannot be changed.
E.
B.
F.
A.
EN