Advanced Programming - Dea REV Instrucciones De Uso

Ocultar thumbs Ver también para REV:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 57

7 ADVANCED PROGRAMMING

Here are some added programming procedures relating to remotes memory management and advanced confi guration of the control
inputs.
1 Deletion of memorized transmitters
1.1 Deletion of all transmitters
1. Scroll down the parameters until you visualize P004;
2. Confi rm by pressing on the
3. When "
" is fl ashing, press the
onds;
4. Release the
key as soon as "
5. All memorized transmitters have been deleted (display
shows again P004).
1.2 How to search and delete a transmitter
1. Scroll down the parameters until you visualize P006;
2. Confi rm by pressing on the
3. By pressing on
and
, keys, select the transmitter you
want to delete (eg.
);
4. When "
" fl ashes, confi rm the deletion by pressing
the
key for a few seconds;
5. Release the
key when appears "
6. The selected transmitter is deleted (display shows again
P006).
2 Resetting of default parameters
1. Scroll down the parameters until you visualize P007;
2. Confi rm by pressing on the
3. When "
" fl ashes, press the
4. Release the
key as soon as "
Default parameters for the confi guration currently in
use are restored;
5. At the end of the operation display returns to P007.
Warning: After you restore the default parameters, you
must program the control panel again and adjust all ope-
rating parameters, in particular, remember to properly set
the confi guration of parameters (P028 - P029 - P030 –
operator confi guration).
Warning: For reversible motors with electro-brake, remem-
ber to set P062=3 at the end of the procedure.
3 Locking-Unlocking access to programming
By using a "dip-switch" remote (regardless of the type of remotes already memorized) it's possible to lock-unlock access to the program-
ming of the control panel to avoid tampering. The remote setting is the locking-unlocking code verifi ed by the control board.
3.1 Locking access to programming
1. Scroll through the parameters with the buttons
and
until the display shows P008;
2. Access the parameter by pressing the button
3. The display shows alternately the writing
to indicate that the control board
is waiting for the transmission of the block code;
4. Within 10 seconds press CH1 on the "TX Master",
the display shows
to the list of parameters;
5. Access to programming is locked.
key;
key for a few sec-
" stops fl ashing;
key;
";
key;
key;
" stops fl ashing;
;
before returning
29

Publicidad

Tabla de contenido
loading

Tabla de contenido