Tabla de contenido
Publicidad
The following Warnings are for the safe setup, use, grounding, maintenance and repair of this equipment. The excla-
mation point symbol alerts you to a general warning and the hazard symbol refers to procedure-specific risks. Refer
back to these Warnings. Additional, product-specific warnings may be found throughout the body of this manual
where applicable.
FIRE AND EXPLOSION HAZARD
Flammable fumes, such as solvent and paint fumes, in work area can ignite or explode. To help prevent fire and explosion:
•
Use equipment only in well ventilated area.
•
Sprayer generates sparks. When flammable liquids are used near the sprayer or for flushing or cleaning, keep sprayer
at least 20 feet (6 meters) away from explosive vapors.
•
Do not clean with materials having flash points lower than 70° F (21° C). Use water-based material or mineral spir-
its-type material only. For complete information about your fluid, request the MSDS from the fluid distributor or retailer.
•
Eliminate all ignition sources; such as pilot lights, cigarettes, portable electric lamps, and plastic drop cloths (potential
static arc).
•
Keep work area free of debris, including solvent, rags and gasoline.
•
Do not plug or unplug power cords, or turn power or light switches on or off when flammable fumes are present.
•
Ground all equipment in the work area. See Grounding instructions.
•
Use only grounded hoses.
•
Hold gun firmly to side of grounded pail when triggering into pail.
•
If there is static sparking or you feel a shock, stop operation immediately. Do not use equipment until you identify
and correct the problem.
•
Keep a working fire extinguisher in the work area.
SKIN INJECTION HAZARD
High-pressure fluid from gun, hose leaks, or ruptured components will pierce skin. This may look like just a cut, but it is a
serious injury that can result in amputation. Get immediate surgical treatment.
•
Do not point gun at anyone or at any part of the body.
•
Do not put your hand over the spray tip.
•
Do not stop or deflect leaks with your hand, body, glove, or rag.
•
Do not spray without tip guard and trigger guard installed.
•
Engage trigger lock when not spraying.
•
Follow Pressure Relief Procedure in this manual, when you stop spraying and before cleaning, checking, or servicing
equipment.
PRESSURIZED EQUIPMENT HAZARD
Fluid from the gun/dispense valve, leaks, or ruptured components can splash in the eyes or on skin and cause serious
injury.
•
Follow Pressure Relief Procedure in this manual, when you stop spraying and before cleaning, checking, or servicing
equipment.
•
Tighten all fluid connections before operating the equipment.
•
Check hoses, tubes, and couplings daily. Replace worn or damaged parts immediately.
PERSONAL PROTECTIVE EQUIPMENT
You must wear appropriate protective equipment when operating, servicing, or when in the operating area of the equipment
to help protect you from serious injury, including eye injury, inhalation of toxic fumes, burns, and hearing loss. This equip-
ment includes but is not limited to:
•
Protective eyewear
•
Clothing and respirator as recommended by the fluid and solvent manufacturer
•
Gloves
•
Hearing protection
309970E
Warnings / Mises en garde / Advertencias
WARNING
5
Publicidad
Tabla de contenido
