Initial Oil Fill - Westinghouse iGen2300 Guía De Rápida Instalación

OPERATION

INITIAL OIL FILL

BEFORE ADDING ENGINE OIL, REVIEW
SAFETY SECTION STARTING ON PAGE 5.
NOTICE
Engine oil must be added when the inverter is on a
flat, level surface, or an inaccurate reading may result.
Do not overfill. If the engine is overfilled with oil, it can
cause serious engine damage.
1. Turn the locking knob on the engine access panel and
set aside (see Figure 1).
Figure 1: Engine Service Panel
2. Pull out oil access insert at the bottom of the case and
clean the area around the oil fill/drain plug. Unscrew
and remove plug (See Figure 2).
Figure 2: Oil Fill/Drain Plug
14 | Westinghouse Outdoor Power Equipment
3. Using the supplied funnel and oil, slowly pour oil
into the engine. Stop frequently to make sure you
do not overfill (see Figure 3).
Figure 3: Oil Funnel
4. Do not overfill, if oil level is too high, oil will drain
out through the fill plug. See correct oil level in
Figure 4.
Figure 4: Engine Oil Correct Level