Assembly; Carton Contents; Initial Oil Fill - Westinghouse iGen2200 Manual De Usuario

ASSEMBLY

CARTON CONTENTS

1. Carefully open the carton.
2. Remove and save the instruction manual, oil bottle, oil
funnel, spark plug socket wrench, and screwdriver.
3. Remove and discard the packing materials.
4. Unfold the top of the plastic bag enclosing the generator.
5. Carefully cut the vertical corners of the carton to access
the generator.
6. Recycle or dispose of the packaging materials properly.
CARTON CONTENTS
• User manual
• Quick Start Guide/Maintenance Schedule
• 0.37 Quart (0.35 Liter) bottle of SAE 10W-30 Oil
• Screwdriver
• Spark plug socket wrench
• Oil Funnel
If any parts are missing, contact our service team at
service@wpowereq.com or call 1-855-944-3571.
10 | Westinghouse Outdoor Power Equipment, LLC

INITIAL OIL FILL

THIS GENERATOR HAS BEEN SHIPPED WITHOUT
OIL. Do not attempt to crank or start engine before it has
been properly serviced with recommended oil. Failure to
add engine oil before starting will result in serious engine
damage.
Use of 2-stroke/cycle oil or other unapproved oil types
can cause severe engine damage that is not covered
under warranty.
The included, recommended oil type for typical use is
10W-30 engine oil. If running the generator in extreme
temperatures, refer to the following chart.
Recommended Engine Oil Type
5W-30
5W-30 Synthetic
°F -20 0 20
°C
-28.9 -17.8 -6.7
Ambient temperature
1. On a level surface, remove the engine service cover
and oil dipstick.
2. Using the supplied funnel and oil, add oil into the engine.
Note: As residual oil from the factory may remain in the
engine, add the oil incrementally near the end of the
bottle to prevent overfilling the engine. See Engine
Oil Level Check in the Maintenance section.
3. Replace the oil dipstick and hand-tighten.
4. Replace the engine service cover.
NOTICE
NOTICE
10W-30
10W-40
40 60 80 100
4.4 15.6 26.7 37.8
120
48.9