Initial Oil Fill; Wh1000I - Westinghouse WH1000i Manual Del Propietário

INITIAL OIL FILL

NOTICE
Engine oil must be added when the inverter is on
a flat, level surface, or an inaccurate reading may
result. Do not overfill. If the engine is overfilled with
oil, it can cause serious engine damage.

WH1000i

1. Loosen the screw and remove the engine service
panel to access the oil fill/drain plug
Figure 10 – WH1000i Engine Service Panel
2. Clean area around oil fill/drain plug and remove
plug (see Figure 11).
Figure 11 – Oil Fill/Drain Plug
3. Using the supplied oil fill container and oil, fill the
container to the 2.0 mark on the container. Do not
overfill
(see Figure 10).
Do not tilt the inverter to add oil. It must be filled on a
flat, level surface.
4. Add the 200 ml of oil to the engine
5. Fill the container with oil again only to the 1.0 mark.
OPERATION
(see Figure 12).
2.0
1.5
1.0
0.5
Figure 12 – Oil Fill Container
NOTICE
Figure 13 – Adding Engine Oil
(see Figure 13).
21