Reading The Error Memory - Abicor Binzel MFS-V3 eBOX Instructivo De Servicio

eBOX
10 Troubleshooting
DANGER
Risk of injury and machine damage when handled by unauthorized persons
Incorrect repair work and changes of the product may lead to significant injuries and damage to the device. The product
warranty will be rendered invalid if work is carried out on the product by unauthorized persons.
• Operating, maintenance, cleaning and repair work may be carried out only by qualified personnel
(in Germany see TRBS 1203).
Please observe the attached document "Warranty". Please consult your retailer or the manufacturer in case of any doubts
and/or problems.
NOTICE
• Please also consult the operating instructions for the welding components, such as the power source, welding torch
system, re-circulating cooling unit etc.
Fault Cause
• Control system or component defective
Unit is not
ready for • Gas flow controller defective or set incorrectly
operation
• M-Drive safety switch not actuated
• Motor defective
Wire is not fed
• Defective control lead. No feed or only 100%
feed possible
LED does not • Fuse switched off
illuminate
Tab. 15 Troubleshooting

10.1 Reading the error memory

Please see the information on the SD card instruction leaflet.
BAL.0388.0 • 2018-08-08
Solution
• Ask a Binzel specialist to replace the defective control
system or component
• Ask a Binzel specialist to check and set the gas flow
controller
• Ask a Binzel specialist to check the switch
• Switch off the power to the system
• Ask a Binzel specialist to replace the motor
• Press the reset button
• Replace the feed system
• Check the control lead and the connectors. Replace the
control lead if necessary
• Check that a power supply is available and/or if the light
on the power supply unit illuminates. If not, replace the fuse
10 Troubleshooting
EN - 21