Changing The Door-Opening Direction; Tools Required - THOMSON KGT330NWI Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1

CHANGING THE DOOR-OPENING DIRECTION:

TOOLS REQUIRED:

µ A Phillips screwdriver.
PROCEDURE:
1. Unplug the refrigerator and take everything from the
compartment.
2. Remove the cover from the top hinge. (Fig.1)
3. Loosen the top hinge screws. (Fig.1)
4. Take the door off with an upward movement.
5. Remove the cover of the central hinge screws, and loosen the two screws
holding it in place. (Fig.2)
6. With the screws loose, move the freezer door upward to
release it.
7. Lastly, remove the screws and take out the lower hinge.
(Fig.3)
Fig. 3
Bottom hinge
BEFORE SWITCHING THE REFRIGERATOR ON:
µ Clean the inside with warm water and bicarbonate of soda. Rinse and dry
carefully.
µ Wait for 2 hours before starting, to ensure that the motor lubricants have
stabilised.
µ If the refrigerator has been switched off, wait 4 hours after restarting before
placing food inside.
8. Change the position of the
bottom hinge shaft, placing it on the opposite side.
(Fig.3)
9. If fitted, change the lateral handles to the
other side.
10. Reverse this procedure to refit the doors.
5
Fig. 1 Top hinge
Fig. 2 Central hinge

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido