Test Station Set-Up - MSA Altair QuickCheck Manual De Instrucciones

Test Station Set-up

1. Place the unit:
• on a level surface
• in an atmosphere with an ambient noise
level of 100 dB or less.
2. Test station power requirements are:
• 115-230 VAC 50-60 Hz input
(MSA power supply)
• 6 V output to the test station.
3. Connect power cord into the receptor
at the rear of the unit.
4. To connect tubing, attach:
• one end of tubing
to the regulator barb fitting
• other end of tubing
to the test station barb fitting.
5. Connect regulator to the necessary
gas cylinder.
• See TABLE 1-2 for necessary gas
cylinder concentrations.
• Only the specified gas concentrations
may be used with the Altair QuickCheck
Station.
Table 1-2.
Necessary Gas Cylinder Concentrations
GAS
ALTAIR / CONCENTRATION
ALTAIR PRO USED FOR
SENSORS QUICKCHECK
H 2 S 40 ppm
40 ppm
CO 60 ppm
O 2 5%
NO 2 10 ppm
10 ppm
SO 2 10 ppm
10 ppm
NH 3 25 ppm
25 ppm
CL 2 10 ppm
10 ppm
CLO 2 2 ppm Cl 2
2 ppm Cl 2
HCN 10 ppm
10 ppm
• All Cylinders are: RP - 58 LTRS, 500 PSI
EC - 34 LTRS, 500 PSI
NOTE: Required gas concentrations
are also listed on the bottom of the test station.
CYLINDER PART
TYPE NO.
Econo-Cal 711062
RP 467897
100 LTRS Steel RP 710882
100 LTRS Steel RP 493580
Econo-Cal 711068
RP 808977
Econo-Cal 711070
RP 808978
Econo-Cal 711078
RP 814866
Econo-Cal 711066
RP 806740
Econo-Cal 711082
RP 10028080
Econo-Cal 711072
RP 809351
1-3