Cuff Connection; Setting The Time And Date; Carrying Out A Measurement; Before The Measurement - Microlife BP 3AC1-1 PC Manual De Instrucciones

4.3. Cuff connection

Insert the cuff tube into the opening provided on the left
side of the instrument, as shown in the diagram.

4.4. Setting the time and date

This blood pressure monitor automatically records the time and date of each measurement. This is very
important information as blood pressure normally varies over the course of a day.
1. After new batteries have been inserted the year is blinking in the display. You can adjust the year by
pressing the «M» button. Press the Time button to confirm and switch to month setting.
2. The correct month can be entered by the «M» button. Press the Time button to confirm and switch to
day setting.
3. Please follow the instructions above to set the day, hour and minutes.
4. Once the minutes have been set and the Time button is pressed, the date and time will be displayed on
the screen.
5. If you want to change the date and time again, please hold the Time button down for about 3 seconds
until the year number starts to flash. Now you can enter the new values as described above.

5. Carrying out a Measurement

5.1. Before the measurement

• Avoid eating, smoking as well as all forms of exertion directly before the measurement. All these
factors influence the measurement result. Try to find time to relax by sitting in an armchair in a quiet
atmosphere for about 5 minutes before measurement.
• Remove any garment that fits closely to your upper arm.
• Always measure on the same arm (normally left).
• Take measurements regularly at the same time of day, since blood pressure changes during the course
of the day.
8
M
M