Tabla de contenido
Publicidad
ON
I
A
If voltage indicated on the electrical
rating plate of your machine is
220-240V, ask for light bulb conforming
to following specification.
-Edison type (screw type):
220 ~240V, 15W
Glass shape:
Lamp cap:
Overall length: 56mm
Note:
Always use 110V/230V/240V/
15W bulbs. Bulbs are available
from your local dealer.
OFF
O
T-22
E14
B
35
Maintenance
Changing light bulb
- Switch the machine off "O" and
disconnect it from electricity supply
by removing the mains plug.
- Loosen the bulb cover setscrew (A)
and remove the bulb cover.
- Unscrew the bulb and replace it with
a new one.
- Attach bulb cover and re-tighten the
setscrew.
If voltage indicated on the electrical
rating plate of your machine is 100V,
ask for light bulb conforming to
following specification.
-Edison type (screw type):
100V, 12W
Glass shape:
T-20
Lamp cap:
E12
Overall length: 48mm
If voltage indicated on the electrical
rating plate of your machine is
110-120V, ask for light bulb conforming
to following specification.
-Edison type (screw type):
110 ~120V, 15W
Glass shape:
T-20
Lamp cap:
E12
Overall length: 48mm
Cleaning and lubricating
- Disconnect machine from electricity
supply.
During sewing dust and fluff collect in
and on the machine. This should be
removed regularly.
Your overlocker requires very little
lubrication but if used frequently,
lubricate the points illustrated (B) with
a drop of oil.
Publicidad
Tabla de contenido
