Installation; Electrical Installation - Zanussi ZOB382 Manual De Instrucciones

Problem
The oven lamp does not operate.
Steam and condensation settle on the
food and in the appliance.
If you cannot find a solution to the problem yourself, con-
tact your dealer or the service centre.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

Installation

Warning! Refer to "Safety information" chapter.
Possible cause
The fuse in the fuse box is released.
The oven lamp is defective.
You left the dish in the appliance for
too long .
The necessary data for the service centre is on the rating
plate. The rating plate is on the front frame of the oven
cavity.
50

Electrical installation

This appliance is supplied without a main plug and a main
cable.
The cable
Cable types applicable for installation or replacement:
H07 RN-F, H05 RN-F, H05 RRF, H05 VV-F, H05 V2V2-F
(T90), H05 BB-F.
For the section of the cable refer to the total power (on the
rating plate) and to the table:
Do a check of the fuse. If the fuse is
released more than one time, contact
a qualified electrician .
Replace the oven lamp.
Do not let the dishes to stay in the
appliance for more than 15-20 mi-
nutes after the cooking ends.
.........................................
.........................................
.........................................
A
B
Warning! Only a qualified and competent person
must do the electrical installation.
The manufacturer is not responsible if you do not
follow safety precautions from chapter "Safety".
Remedy
25