Installation - Zanussi ZOP38903 Manual De Instrucciones

Ocultar thumbs Ver también para ZOP38903:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Problem
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven lamp does not oper-
ate.
The oven does not heat up.
The fan does not operate. The
display shows
or
The display shows an error
code.
It takes too long to cook the
dishes, or they cook too quick-
ly.
Steam and condensation col-
lect on the food and in the
oven.
If you cannot find a solution to the problem
yourself, contact your dealer or the service cen-
tre.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

Installation

20
Possible cause
The appliance is deactivated.
The clock is not set.
The necessary settings are not
set.
The automatic switch-off is on.
The Child Lock is on.
The fuse in the fuse box is re-
leased.
The oven lamp is defective.
The demo mode is activated.
.
There is an electronic fault.
The temperature is too low or too
high.
You left the dish in the oven for
too long.
Activate the appliance.
Set the clock.
Make sure that the settings are cor-
rect.
Refer to "Automatic switch-off".
Refer to "Deactivating the Child Lock".
Do a check of the fuse. If the fuse is
released more than one time, contact
a qualified electrician.
Replace the oven lamp.
1. Deactivate the appliance.
2. Press and hold the button
approximately two seconds. An
acoustic signal sounds.
3. Press and hold the buttons
and
acoustic signal sounds again and
the indicator goes out.
1. Deactivate the appliance with the
house fuse or the safety switch in
the fuse box and activate it again.
2. If the display shows the error
code again, contact the service
centre.
• Adjust the temperature if necessary.
• Follow the advice in the manual.
Do not keep the dishes in the appli-
ance for longer than 15 - 20 minutes
after the cooking ends.
The necessary data for the service centre is on
the rating plate. The rating plate is on the front
frame of the appliance cavity.
.........................................
.........................................
.........................................
Remedy
for
at the same time until the
www.zanussi.com

Publicidad

Tabla de contenido
loading

Tabla de contenido