KOBE Brillia Serie Instrucciones De Instalación Y Manual De Operación página 10

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Ductwork Installation
5.
Use 6" round steel pipe (not provided) to
connect the plastic exhaust on the hood to the
ductwork above. Use duct tape to make all
joints secure and air tight.
Refer to Figure 4.
Wiring to Power Supply
-
If hood is operating normally, connect three
wires (black, white and green) to house wires
and cap with wire connectors.
-
Store wires in the wiring box.
Duct Cover Installation
NOTE:
BE
CAREFUL
ELECTRICAL SCREWDRIVER, DAMAGE TO
THE HOOD MAY OCCUR.
6.
Using reference E from Table 1 and
measurements on pages 13-14, mark the
leveling point for duct cover bracket.
7.
Secure the duct cover mounting bracket to the
wall with two screws (provided). Make sure
all screws are tightened Refer to Figure 5.
NOTE: Inner duct cover will cover the duct
cover bracket.
8.
Slide the entire duct cover onto the hood.
Refer to Figure 6.
WHEN
USING
8
Figure 4
Figure 5
Figure 6

Publicidad

Tabla de contenido
loading

Tabla de contenido