Parkside PTK 1700 A1 Manual De Instrucciones página 59

Anleitung_4340688:_ 07.06.2010
Be sure to observe the safety information
■
and operating and maintenance instructions
issued by the manufacturer, as well as the
dimensions listed in the Technical Data.
It is imperative to observe the accident
■
prevention regulations in force in your area
as well as all other generally recognized
rules of safety.
Note the information published by your
■
professional associations.
Connect up the dust extraction system on
■
all jobs. The operator has to be informed
about the conditions with an influence on
dust development, e.g. the type of material
being processed (source and collection of
the dust), the significance of local
separation arrangements, and the correct
setting of hoods, baffle plates and guides.
Operate the saw only with a suitable
■
vacuum extraction system or a standard
industrial vacuum cleaner.
Never remove loose splinters, chips or
■
jammed pieces of wood when the saw
blade is running.
To rectify faults or remove jammed pieces
■
of wood, always switch off the machine first.
Pull out the power plug!
If the sawing gap is worn, replace the table
■
insert. - Pull out the power plug!
This electric tool complies with the pertinent
■
safety regulations.
Keep your work area clean and tidy. Untidy
■
and unlit work areas can result in accidents.
Keep the tool out of the rain and away from
■
moisture. The ingress of water into an
electric power tool increases the risk of an
electric shock.
Be careful, watch what you are doing and
■
use an electric tool sensibly. Never use the
tool if you are tired or under the influence of
drugs, alcohol or medication. A moment of
inattention when using the electric tool can
result in serious injuries.
Do not use an electric power tool if the
■
switch is defective. An electric power tool
that cannot be switched on or off is
dangerous and must be repaired.
Keep unused electric tools out of the reach
■
of children. Do not allow people who are not
familiar with the tool or who have not read
16:35 Uhr Seite 59
these instructions to use the tool. Electric
tools are dangerous if they are used by
inexperienced people.
Keep your cutting tools sharp and clean.
■
Carefully maintained cutting tools with sharp
cutting edges will jam less and are easier to
control.
If the connection lead on the electric tool is
■
damaged, it must be replaced by a specially
prepared connection lead available from our
customer service organization.
Have your tool repaired only by trained
■
personnel using only genuine spare parts.
This will ensure that your tool remains safe
to use.
The equipment has to be set up where it
■
can stand securely.
All covers and safety devices have to be
■
properly fitted before the equipment is
switched on.
It must be possible for the blade to run
■
freely.
When working with wood that has been
■
processed before, watch out for foreign
bodies such as nails or screws etc.
Before you actuate the On/Off switch, make
■
sure that the saw blade is correctly fitted
and that the equipment's moving parts run
smoothly.
Use clamps to stop the workpiece slipping.
■
This is safer than using your hand.
Follow the instructions for lubrication and
■
changing tools.
Keep handles dry, clean and free from oil
■
and grease.
Keep the push stick or handle for a push
■
block at the machine at all times, even when
you are not using them.
Do not cut rebates or grooves without fitting
■
a suitable guard, e.g. a tunnel-type guard,
over the saw table.
While you are moving the machine it is best
■
to cover the top part of the blade, for
example using a guard.
Use only the transport handles punched into
■
both sides of the housing for transporting
the equipment.
Never use the safety devices for handling or
■
transporting purposes.
GB/
MT
59