Description; Components; Mode Of Operation; Standard Equipment - WALTHER PILOT GM 1030P Instrucciones De Servicio

VERSION 12/2020
OPERATING MANUAL
5

DESCRIPTION

5.1

COMPONENTS

Designation
A Suspension hook
B Needle stroke regulator
C Needle stroke regulator lock
D Shaping air regulator
E Air connection
F Air regulation
G Trigger
H Fluid inlet
I Nozzle / air cap
J Air cap nut
K Spray gun housing
5.2

MODE OF OPERATION

When pressing the trigger (G), first the atomizing air is released and then the material needle is
retracted. In this way, the spray product moves through the nozzle (I) to the workpiece surface
to be coated. The closing of the spray gun takes place in the reverse order. The product flow rate
is dependent on the diameter of the nozzle (I) and the setting of the material pressure on
the pressure vessel or product pressure regulator. The spray pattern is adjusted optimally
to suit the object being sprayed using the shaping air regulator (D). The flow rate can be
regulated by rotating the needle stroke regulator (B) and this setting can be fixed using
the needle stroke regulator lock (C). The air supply is regulated using the air regulator (D).
5.3

STANDARD EQUIPMENT

Designation
1 CE Declaration of Conformity
1 Operating manual, in German
1 Operating manual in local language see Chapter
For special versions the delivery note applies.
DOC2422648
K
J
I
I
H
G
PILOT GM 1030P
J
K
H
G
B_06967
1.3
A
A
D
B
C
B
C
D
E
E
F
F
16