Machine Start And Stop - Clarke Vantage 17 Battery Libro De Instrucciones

ENGLISH

MACHINE START AND STOP

Start
1. Prepare the machine according to the procedure shown in
the previous paragraph.
2. Lower the squeegee (A, Fig. 15) by pushing the lever (B)
downwards.
3. Turn the solution flow control lever (C, Fig. 15) to one of the
following positions, according to the type of cleaning to be
carried out:
• ECO system : When the lever (C, Fig. 15) is in the "ECO"
position (D), the machine works in a special condition
of programmed water "economy" usage; as the water
flow is set and constant, the machine can work with a
cleaning time of 70-80 minutes [0.08 gal/min (0.3 liters/
min)].
• Variable system : When the lever is turned to the left
(variable flow), it is possible to increase the capacity up
to 0.26 gal/min (1 liter/min) (E, Fig. 15).
During machine operation, it is not possible to completely
close the water flow to the brush/pad.
4. Turn the switches (A and B, Fig. 14) to the "I" position.
NOTE
If the green indicator light (C, Fig. 14) turns on, the
machine is ready to be used.
If the yellow (D) or red indicator light (E) turns on, it is
necessary to charge the batteries (see the procedure
in the Maintenance chapter).
5. While keeping both hands on the handlebar (G, Fig. 15),
start the machine by pressing one or both the activation
switches (F).
Machine Stop
6. Release the switches (F, Fig. 15).
7. Turn the switches (A and B, Fig. 14) to the "0" position.
8. Lift the squeegee by pushing the lever (B, Fig. 15) completely
upwards.
9. Lift the brush/pad by activating (B, Fig. 16) the transport/
parking device (A) after inserting the relevant pin (C).
14
Figure 14
Figure 15
Figure 16
Operator's Manual - Vantage 17 Battery