Recommendations Of Importance - Astralpool PoolWatch Basic Eco Manual De Instrucciones

8. STARTING OF POOLWATCH BASIC ECO pH / INORGANIC CHLORINE
Once finished with the installation and programming, starting of PoolWatch Basic Eco pH / Inorganic Chlorine is carried out.
1.- Close sample -taking valve (9)
2.- Open water inlet (1) and outlet (18) valves.
3.- Start filtering pump.
4.- Open valve (14) in order to regulate flow in the analysis chamber, letting water circulate inside and adjust its flow to 30 lts/h
(When he float top (I) emerges over the signal engraved on the front part of the analysis chamber).
5.- Switch dispenser pumps on and choose a work proportion that suits swimming
pool volume.
ATTENTION: It is essential that when we start PoolWatch Basic Eco pH / Inorganic Chlorine we have water in the
following conditions:
- Clear.
- pH value between 7 - 7.8
- Chlorine value between 1-1.5 ppm
WARNING: The swimmingpool water have not posible existence cianuric acid (= 0ppm Cys).
ELECTION OF WORKING VALUES IN THE POOLWATCH BASIC ECO pH / Inorganic Chlorine
It is recommended to have the information about the working margins that the legislation allows respecting Chlorine and pH levels in
the place where it is installed. In the case, we recommend to work with low values (close to the 7.2), hence we have a higher percentage
of free chlorine in form of active disinfectant.
One recommendation is 7.25 (pH) and 1,25 ppm Cl, although you will take the final decision according to the filtering base, quantity of
swimmers, etc.
To have a higher precision in the chlorine reading, it is recommended to make the "ADJUST DPD" in an approximate SP value to the
one we have chosen. If these values are distant one to the other, the Chlorine reading may not be accurate.
We recommend that for the set monitoring you use a photometer PC-Checkit.

9. RECOMMENDATIONS OF IMPORTANCE

- When the filtering system works with the help of continuous flocculation, you have to take into account to inject the flocculating
after the water connection to the analysis chamber.
- Do not put any chemical product in the pool, in the skimmers or in the balance tank. (Example: cartridge or tablets flocculant).
these could go directly to the PoolWatch Basic Eco pH / Inorganic Chlorine, and damage seriously their electrodes.
- When a filter cleaning is done or when you use a manual bottom cleaner, you have to close the input water valve to the
PoolWatch Basic Eco pH / Inorganic Chlorine (in the collar intake) to avoid the dirt go inside the PoolWatch Basic Eco pH /
Inorganic Chlorine circuit.
- A constant flow of 30 litres per hour has to go through the analysis chamber.
When a water recuperation treatment of the pool is done, we will not let water go inside the analysis chamber. To do this, it is
-
essential to install a valve in the place where the water of the PoolWatch Basic Eco pH / Inorganic Chlorine is taken and keep
it closed until the recuperation treatment is finished and the water values in the pool are the normal ones again.
10 Ref: PW Basic-Eco-28472-gb-W01