Thermador Professional PRO HARMONY PRG30 Manual De Instalación página 12

4. After removing the pallet bolts with two ½" (13mm)
wrenches (one to hold bolt at the bottom while the
other is loosening the nut at the top), the range may be
lifted and removed from the pallet.
Pallet
Figure 5: Removal of the Four Shipping Bolts
5. Due to the weight, a furniture dolly with soft wheels or
an air lift should be used to move this unit. The weight
must be supported uniformly across the bottom
(Figure 6).
Range must be
uniformly
supported
by braces
provided
on bottom
of range
English 10
Figure 6: Dolly Positioning
6. After transporting the range by dolly close to its final
location, the range can be tipped back and supported
on the rear legs while the dolly is carefully removed.
THE FLOOR UNDER THE LEGS SHOULD BE
PROTECTED BEFORE PUSHING THE UNIT INTO
POSITION.
• The anti-tip device must be installed ("Step 4:
Installing Anti-Tip Device"), gas and electrical
connections should be made ("Step 5: Gas
Requirements and Hookup" and "Step 6: Electrical
Requirements, Connection & Grounding"), and the
backguard installed ("Step 7: Backguard
Installation (optional)") before the range is placed
in its final position.
• For proper performance, the range must be level.
See "Step 9: Placing and Leveling the Range" on
page 23 for leveling instructions.
7. Replace the kick panel. It is important that the
screws retaining the kick panel are secure to
prevent accidental access to hot surfaces.
8. Ensure that the burner caps are correctly seated on the
burner bases of the rangetop.
• Remove all tape and packaging before using the
appliance. Please, recycle the packaging material,
as all THERMADOR
material is recyclable. Never allow children to play
with packaging material.
®
appliance packaging