Glass Shelves; Refrigerator Drawers - Sub-Zero Designer Serie Guía Del Usuario Y Servicios

Storage
Refrigerator Storage

GLASS SHELVES

To reposition a glass shelf:
To remove, tilt the shelf up, then lift up and out. Refer
1
to the illustration below.
To reinstall, insert the shelf in the tracks along the back
2
wall, then lower the front until it locks into position.
The stationary glass shelf at the bottom of the compart-
ment should be placed with the beveled edge facing front.
Rear support legs space the shelf away from the back wall
to ensure proper air flow through the unit.
IMPORTANT NOTE: Use care when handling glass shelves
to prevent breakage or scratching the interior.
CAUTION
Glass shelves should warm to room temperature
before immersing in warm water.
Glass shelf removal
10 | Sub-Zero Customer Care 800.222.7820

REFRIGERATOR DRAWERS

To remove/reinstall a refrigerator drawer:
To remove, pull the drawer open until it stops. Lift the
1
front of the drawer slightly and pull straight out. Refer
to the illustration below.
2 To reinstall, pull the drawer carrier out and align the
bottom of the drawer with the carrier. Slide the drawer
back into position.
To reposition a refrigerator drawer divider:
To remove, pull the divider straight up.
1
2 To reinstall, align tabs on the divider with notches in
the drawer and push down.
Refrigerator drawer removal Refrigerator drawer removal