Glass Shelves; Refrigerator Storage Drawers - Sub-Zero Designer Serie Manual De Instrucciones

Storage
Refrigerator Storage

GLASS SHELVES

To reposition a glass shelf:
To remove, tilt the shelf up, then lift up and out. Refer
1
to the illustration below.
To install, insert the shelf in the tracks along the back
2
wall, then lower the front until it locks into position.
IMPORTANT NOTE: Use care when handling glass shelves
to prevent breakage or scratching the interior.
CAUTION
Glass shelves should warm to room temperature
before immersing in warm water.
Glass shelf removal

REFRIGERATOR STORAGE DRAWERS

To remove and install a refrigerator drawer:
To remove, pull the drawer open until it stops.
1
2 Lift the front of the drawer slightly and pull straight out.
Refer to the illustration below.
3 To install, pull the drawer carrier out and align the
bottom of the drawer with the carrier.
4 Slide the drawer back into position.
To reposition a refrigerator drawer divider:
To remove, pull the divider straight up.
1
2 To install, align tabs on the divider with notches in the
drawer and push down.
Refrigerator drawer removal
subzero.com | 11