Festo CLR-12 Instrucciones De Utilizacion página 29

CLR−...
The clamping procedures listed in the following table are not permitted:
Clamping moving parts
Fig. 21
Make sure that the maximum permitted loadings are not exceeded.
S
If set correctly, the clamping finger must reach the end position safely without
knocking hard against it.
Commissioning setting the clamping screw
Adjust the clamping screw on the clamping finger. When doing this note the
S
following points:
Relevant points
Always counter hold on the clamping
finger (e.g. with a spanner wrench at
spanner flat 6 ).
Adjustments may only be undertaken
when the device is at a stand.
Festo CLR−... 0604c English
Clamping within the
swivel procedure
Explanation
At no time may there be a torque on the
guide sleeve (a spanner sliding from the
spanner flat can, under circumstances,
damage the internal guide contour of the
guide sleeve).
Clamping on a sloping
surface
29