Festo CLR-12 Instrucciones De Utilizacion página 30

CLR−...
Relevant points
The permitted clamping range X is
maintained. This includes a safety
distance from the swivel movement and
from the end of the stroke. The safety
distance is in each case approx. 2 mm
Key to the following diagram:
a) end of swivel movement
b) start of reliable clamping
b) end of reliable clamping
d) end position (no clamping)
The maximum screw−out length is flush
with the clamping finger.
The lock nut of the clamping screw must
be locked with Loctite 24333.
The tightening torque of the locking nut is
maintained (see following table).
Fig. 22
CLR−...
Connecting thread
Tightening torque [Nm]
Fig. 23
Commissioning test run
Start a test run as follows:
S
at first with slow positioning movements
then under conditions of use.
During the test run check that the CLR−... clamps reliably.
S
If the test run is without faults:
End the test run.
S
30
Explanation
12 16 20
M4 M6
3 12
25 32 40
M8
24
Festo CLR−... 0604c English
(a)
(b)
(c)
(d)
50 63
M10
47