Graef SKS 700 Manual De Instrucciones página 47

Problem
The stop illumination
lights red
The stop illumination
pulsates red and the il-
lumination of the blade
and the scaler go out
The unit slips on the
work top while cutting
Blade blocks while
cutting
The connection line
cannot be pushed into
the cable compartment
Cause
Safety instruction - the
stop stands open for a
long time
Safety instruction - the
stop has already stood
open for a long time
The installation surface
or the rubber feet of
the unit are soiled
The unit is overloaded
The connection line is
blocked in the cable
compartment
Solution
Check to see that the
stop is completely
closed after using the
machine. The stop illu-
mination goes out.
Check to see that the
stop is completely
closed after using the
machine. The stop illu-
mination goes out.
Make sure that the
installation surface
and the rubber feet of
the machine are clean
and free from grease.
Select a suitable
installation surface, if
necessary
Interrupt the cutting
process and cautious-
ly remove the slicing
material. Make sure
to use only suitable
goods to be cut and
adjust the cut width ac-
cordingly, if necessary.
Pull the connection line
a bit out of the cable
compartment and
push it in again. While
doing so, check to see
that a short length as
possible of the con-
nection line is grasped.
DE
EN
FR
NL
IT
ES
DK
NO
SE
PL
HU
UKR
47