Página 2
Consult your dealer or an experienced radio/TV technician. Any changes or modifications to the printer that are not expressly approved by HP could void the user’s authority to operate this equipment. Use of a shielded interface cable is required to comply with the Class B limits of Part 15 of FCC rules.
Página 3
4) Software and electronic user guide (on media input tray. 11) Power cord. straight-through media doors. CD-ROM). 5) HP JetDirect 175X print server. Gennemgå pakkens indhold. Kontroller, 6) Monteringsbeslag til printerserver. Klargør pladsen. Placer printeren på en solid at alle dele er blevet leveret.
Página 4
10) Printer straight-through media • Temperature—50° to 91° F (10° to 32.5° C). 6) Long media support. door. 11) HP JetDirect 175X print server. • Relative humidity—20% to 80%. Kontroller omgivelserne. Printeren må ikke Lokaliser delene. 1) Udskriftsbakke til printer.
Página 5
Assembly/Montage Open the toner door. Pull the sides of the door Remove the left side panel. 1) Grasp the left Connect the printer cable. Attach the included forward until the door locks in its open position. side panel using the finger hole. 2) Pull out and USB cable to the USB port on the printer, and Leave the door open until step 8.
Página 6
10 0 1 0 0 1 0 0 Connect the print server. 1) Attach the print 3) Plug the DC power cord from the power 4) The 10 or 100 LED should light, indicating server to a 10Base-T or 100Base-T local module into the power connector on the rear network connection, and the power/status LED network by plugging the network cable into the...
Página 7
Reattach the left side panel. 1) Insert the left Prepare the toner cartridge. Remove the Install the toner cartridge. Insert the cartridge side panel tabs behind the edge of the front toner cartridge from the plastic bag. Remove into the printer, making sure that the toner panel.
Página 8
Close the toner door. The toner cartridge Load the printer tray. 1) Slide the printer 3) Place the media into the media input tray. engages when the door is closed. media input tray in and down at an angle until it Slide the guides until they are flush with the fits securely in the printer.
Página 9
No lights are on. Les voyants ne s’allument pas. Top light is on or blinking. Le voyant supérieur s’allume ou clignote. Attach the power cord. Connect the power Test the printer. Wait until the ready light is Troubleshooting the printer. 1) If no lights are cord to the printer and an AC outlet.
Página 10
τον εκτυπωτή από το ρεύµ ια, περιµ ιένετε 5 λεπτά, κλειστές και ελέγξτε για εµ ιπλοκή χαρτιού. συνδέστε τον πάλι και ξαναδοκιµ ιάστε. Αν εξακολουθούν να υπάρχουν σφάλµ ιατα, επικοινωνήστε µ ιε το Τµ ιήµ ια Εξυπηρέτησης Πελατών της HP.
Página 11
XXXmax Mount the print server. Attach the print server Install the printer software. Choose and 1) Select Install from the autorun screen. If clip onto the bottom of the print server and use install the appropriate CD for your software autorun does not occur, select Start, select the sticky tape to mount the print server to the installation.
Página 12
If you had any computer. 3) Run the Apple Desktop Printer problems, refer to the troubleshooting chapters utility and select HP Printer (USB) or, for in the electronic user guide or call AppleTalk, select the printer in the Chooser.
Plug & Play Installing on Windows 98 and Millennium 4) Select Specify a location, then type Installing on Windows 2000 (USB). 1) Quit all x:\98USB\ (where x is the letter of your (USB). 1) Quit all programs. 2) In the Add New programs.
Página 14
4) Check Specify a location. 5) Under Copy manufacturer’s files from, type x:\2k\ (where x is the letter of your CD-ROM drive), and click OK. 6) Click Next. 7) Follow the instructions on your screen. 4) Marker Angiv en placering. 5) Indtast x:\2k\ (hvor x er betegnelsen på...