Publicidad
AHT Cooling Systems GmbH
WARNING
Danger of tilting of the device. People's
bodies can be jammed.
► Remove the transport pallet only when
the stable, final installation position has been
reached.
► Use an anti-tilt device.
► The device must only be installed with
anti-tilt protection.
► Anti-tilt installation service (see → Fig.
7.1) must only be removed again when the
danger of tilting is no longer present. Fuse
protection, e.g. by wall or opposite device for
island installation.
(Anti-tilt installation service is supplied as an
accessory by the installation service.)
► Additional device-specific anti-tilt device
(see → Fig. 7.2) must no longer be removed
after installation.
► Observe the separate mounting
instructions.
► If you have questions, contact the
maintenance service (see → Chapter 10.4).
Fig. 7.1: Anti-tilt
protection Installation
service
WARNING
For devices of type R-290: If the
refrigerant circuit is damaged, the
refrigerant can escape and create an
explosive gas/air mixture. Risk of fire
(see →Chapter 1.6.2.1).
►Do not close the ventilation openings
in the device housing (e.g. front
ventilation grilles or upper air conduits).
If accessory parts are to be installed,
care must be taken to ensure that no
ventilation openings are closed.
► The device must only be installed in
well-ventilated areas.
► Do not install the device in cellars or
lowered areas.
► Channels and wall penetrations
must be sealed underneath and behind
the device, in accordance with fire
protection laws.
► Drilling or other work on the device
is not permitted.
► Do not squeeze or bend pipes.
Fig.7.2: Device-specific
tilt protection
► Minimum area for installation room
300m²
Improper assembly of the shelves/display
shelves. Risk of injury due to falling of
shelves/display shelves or as a result of
the shelves/display shelves filled with
goods.
► Displays/display shelves must fully
engage in the slots provided during
suspension.
Entering the device areas.
Cutting injuries in the case of material
breakage. Danger of falling. Impact
hazard due to the possibility of falling
goods.
► Do not climb onto or into the device.
Sharp edges of the device. Heavy
device parts. Cutting injuries to the
hands. Hands can be jammed.
► During setup and installation, pay
attention to fingers and hands.
► Wear protective gloves.
NOTICE
• Material and property damage in the case of
faulty installation.
► Set up the device in the operating position and
in a stable position.
► Set up the device only on the designated
adjustable feet.
► Do not expose the device to heat radiation at
the installation site.
► Do not expose the device at the installation site
to the direct action of air conditioning and
ventilation.
Material, property and environmental damage
•
caused by damage to the refrigerant circuit.
► Drilling or other work on the device is not
permitted.
► Do not squeeze or bend pipes.
• Material damage caused by loss of stability and
solidity of the device. Deformation of the display
shelves.
► Install the device rear panel correctly with
display shelves.
► The device side wall and side display shelf must
be present.
► The bracket must be correctly inserted into the
rear panel.
► Insert the display shelves at the same height.
- For hygiene reasons, do not stick any advertising
films or other materials onto the device.
- The temperature display, safety instructions and
power rating plate (see → Chapter 2.2.1) must
always be kept clear.
45
CAUTION
CAUTION
CAUTION
Publicidad
Capítulos
