Haier HDP18PA Manual Del Usuario página 18

HDP18PA-MANUAL 4/9/02
Understanding the Venting Process:
• In this process, the hot steam from the dishwasher is being drawn into the drain
pump through its vacuum force and the mix condensation of water and air is
being discharged through the discharge hose from the back of the unit.
Delay Start Option:
Press "Delay Start" button to delay the starting time for a wash cycle. You can delay
the starting time for a wash cycle between 1 to 9 hours. The machine will count
down and start automatically at the pre-set time.
Follow the steps below to delay start:
1. Press the "Delay Start" Button to select between 1-9 hours.
2. Once you have set the hours to Delay Start, select the proper wash cycle and
your options. Press the Start button to activate the process. The light of selected
cycles and options will blink.
3. Close the door properly by making sure that door latch is locked.
4. The wash cycle will start automatically at the appropriate time.
5. To cancel, press On/Off button, wait approximately 30 seconds and reset.
4:22 PM Page 18
TUB
drain hose
hot
stream
drain
pump
one-way valve
English
hot air
and
water
16