Troubleshooting - Haier HDP18PA Manual Del Usuario

HDP18PA-MANUAL 4/9/02

Troubleshooting

Dishwasher does not work:
• Check if the unit is plugged in. The plug may have come loose.
• Check if the electrical wall receptacle is of proper voltage.
• Check if circuit breaker needs to be reset or if the fuse needs to be replaced.
• Check if the unit is on "Off" mode.
• Check if the door is open. You may have to close the door properly.
Dishware and glassware/flatware are cloudy
and not cleaned:
• Use of old or poor detergent.
You need to make sure that detergent is fresh.
• The water may be hard in your area.
You may need to install water softener.
• Spray arms may be blocked.
You may need to rearrange dishware and utensils.
• Water pressure may be low.
You may need to adjust the water pressure.
Make sure it is between 20 to 120 (PSI).
• Water temperature may be lower than what is recommended.
(120 Degree F / 49 Degree C) You may need to adjust water regulator.
• Overloading of dishware.
You may need to rearrange or remove some dishware from the load.
• May have selected wrong cycle.
You may need to select proper cycle.
Dishes are not dry:
• Vented dry option is off.
You need to check if vented dry option is "ON" position.
• Low water temperature.
You may need to regulate water temperature to 120 Degree F / 49 Degree C.
4:22 PM Page 24
English
22