R Ecording From The Built-In Cd - Pioneer DEH-P900HDD Manual De Operación

Digital and analog recording
This product is intended for digital recording
from the built-in CD player to the music server.
Recording from sources other than the built-in
CD, such as multi-CD or AUX, will be recorded
in analog. While digital recordings can be made
with less loss of quality, we recommend record-
ing from the built-in CD.
• It is not possible to digitally copy music to the
music server if it was digitally recorded from
CDs (such as CD-R).
This is set by SCMS, the Serial Copying
Management System, which has been devel-
oped to prevent serial copies (copies of
copies). (See page 74.)
• Analog recordings are stopped automatically
after two hours. To continue recording to the
same playlist file, press REC and restart the
recording.
Bit rate
The bit rate can be selected for each recording.
This alters the sound quality and recording
time. (See page 28.)
Recording range
The range of recording from the built-in CD or
multi-CD player is selectable. (See page 28.)
R
ecording from the built-in CD
Recording from CD-ROM is not possible. Not all
recordings may be made from CD-R, CD-RW
and other formats for reasons of copyright pro-
tection. (SCMS) (See page 74.)
1. Press OPEN to open the front panel.
2. Insert a CD into the CD loading slot.
CD loading slot
3. Close the front panel.
4. Press and hold REC until you have the
5. Press FUNC to select the record mode
6. Press R.MODE to select the recording
7. Press BAND to cancel the record mode
8. Press 2 2 or 3 3 to select the desired track.
9. Press REC to start the recording.
10.Press BAND to cancel the record standby
CD EJECT button
record standby status.
"Ready" and "M.Server pause" appear in
sequence and the product goes into the
record standby status.
setting mode.
range.
Press R.MODE repeatedly to switch
between the following ranges:
Disc (disc recording) = Track (one-track
recording)
• Disc (disc recording) will record the disc
you are listening to from the current track
to the end of the disc. When disc recording
has been interrupted, continued recording
from the interrupted track is possible.
(Refer to "Selecting the recording range"
on page 28.)
• With Track (one-track recording), you can
only record the track you are currently lis-
tening to.
setting mode.
Recording starts automatically from the
beginning of the track being listened to.
• When the recording ends, "M.Server
pause" is displayed and the product goes
into the record standby status.
status.
Continued overleaf.
26