Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
S
electing the recording range
It is possible to select the recording range when
recording from a CD.
1. In record standby, press FUNC to select
the recording mode setting mode.
2. Press R.MODE to select the recording
range.
Press R.MODE repeatedly to switch
between the following recording ranges:
Built-in CD recording
Disc (disc recording) = (Continue (continu-
ous recording)) = Track (one-track recording)
• Disc (disc recording) will record the disc
you are listening to from the current track
to the end of the disc.
• Continue (continuous recording) continues
recording from the interrupted disc record-
ing to the last track of the CD. (Even when
a track other than the interrupted one is
selected, recording will be performed from
the interrupted track.)
• With Track (one-track recording), you can
only record the track you are currently lis-
tening to.
Note:
• When Disc (disc recording) has been interrupted,
and record standby is performed again, Continue
(continuous recording) will be performed, except in
the following cases.
* In case of interruption because of an error.
* When the CD has been removed after the interrup-
tion.
* In case of recording with "Track" after the inter-
ruption.
* When the interruption has been caused by discon-
necting the yellow lead (+ Battery) of this product.
• With Disc (disc recording), you cannot select and
record only the track to be recorded. Unwanted
tracks can be deleted from the music server after
recording. (See page 35.)
Multi-CD Recording
All (all tracks recording) = Track (one-track
recording)
• With Track (one-track recording), you can
only record the track you are currently lis-
tening to (not from the beginning of the
track).
• On All (all tracks recording) you can record
all tracks from the one you are listening to
until you stop recording. (No rewind to the
beginning of track or disc.)
S
electing the recording quality
When recording it is possible to select the
sound quality. The larger the recording bit rate
number, the higher the sound quality, although
the total recording time will be shorter.
1. In record standby, press FUNC and then
press RATE to select the recording bit
rate mode.
2. Press RATE to select the recording bit
rate.
Press RATE repeatedly to switch between
the following setting:
132 kbps = 105 kbps
Note:
• The bit rate allows digital and analog recordings to
be recorded in separate settings. (There is no need
to change the setting when you wish to keep the bit
rate previously set.)
28
Publicidad
Tabla de contenido
