Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Music Server Recording
Note:
• If REC is pressed during recording, recording is ter-
minated.
• In the event of skipping, the recording will revert to
the beginning of the track (retry function).
• On record standby, the current track is repeated.
This is cancelled when recording begins.
• Even if the random, track scan and pause are set to
on, the current track is repeated when the mode is
switched to the record standby status. When the
recording is started, the repeat play is canceled.
• Fast forward and fast reverse do not operate when
the product is on record standby.
S
witching CD information
When recording from the built-in CD, you can
switch CD information during record standby or
recording.
• Press DISP to change the CD information
display.
Press DISP repeatedly to switch between
the following displays:
Recording range "Disc" and "Continue"
Play time = remaining disc time = total disc
time
Recording range "Track"
Play time = remaining track time = total
track time
R
ecording from a source other
than the built-in CD
This product can make analog recordings from
other equipment.
1. Press SOURCE to select the desired
source.
Press SOURCE until the desired source
appears.
2. Press and hold REC until you have the
record standby status.
"Ready" and "M.Server pause" appear in
sequence and the product goes into the
record standby status.
• When performing multi-CD recording, you
can set the recording mode (refer to
"Selecting the recording range" on page
28) and the bit rate (refer to "Selecting the
recording quality" on page 28).
27
• When recording from a source other than
the multi-CD (such as a TV tuner or AUX
output, etc.), the bit rate should be set only
as specified (refer to "Selecting the record-
ing quality" on page 28.)
3. Press REC to start recording.
Recording begins as soon as REC is
pressed.
• When performing multi-CD recording,
press 2 or 3 right before pressing REC to
select the track.
4. Press REC again to stop the recording.
"Ready" and "M.Server pause" appear in
sequence and the product goes into the
record standby status.
5. Press BAND to cancel the record standby
status.
Note:
• If the CD sound from the source CD falls below a
certain level, a track number will be added automat-
ically. By pressing 5 during recording, it is possible
to add a track number manually (up to 400).
• Depending on the recording source CD, the unit
may determine a track ends in the middle or may
not be able to determine the end of a track.
• If the CD skips during recording, it will be recorded
as is.
• When recording where there is a lot of vibration,
such as on the road, track numbers will be added
automatically.
R
ecording function menu
The recording function menu has the following
functions:
Note:
• If you do not operate the function within about 30
seconds, the display is automatically returned.
• The record mode setting mode (R.MODE) is dis-
played for settings only for CD recording.
Publicidad
Tabla de contenido
