Basic operations (continued)
Magnify function
Part of an image can be displayed magnified.
(refer to page 10)
1
Press the MAGNIFY
• The center part of the image will be displayed magnified approximately 2x.
Changing the magnification ratio
2
Press the MAGNIFY
• When this button is pressed, the image will be displayed even larger.
3
Press the MAGNIFY
• When this button is pressed, the image will be displayed even smaller.
Moving the display area
4
Press the POSITION button.
5
Press the DISK PAD up, down, left and right buttons.
• The magnified area will move in accordance with the button pressed.
Returning to normal display
6
Press the MAGNIFY OFF button.
Caution
• When there is no video signal input, Magnify is not effective when the video signal input is
outside the sync range.
• The magnify function will be cancelled when the input select button is pressed or the display
mode of the PC being used for display is changed.
• The Magnify function will be cancelled after the operations such as "AUTO", "KEYSTONE".
16
+
button.
+
button.
–
button.
VIDEO
LASER
STANDBY/ON
5
MENU
1,2
FREEZE
MAGNIFY
3
OFF
P in P
BLANK
AUTO
RGB
POSITION
4
RESET
6
VOLUME
MUTE
TIMER