Connection To The Video Signal; Connection To The Rgb Signal - Hitachi CP-X958W Manual De Instrucciones

Connection to the video signal terminals
1. Input signals
S-VIDEO signal
VIDEO signal
Audio signal
2. Signal input jacks
The priority sequence of the video input jacks is as follows.
Caution
(1) S-VIDEO input jack
When video signals are being projected, the audio input by the video is output to the audio
output jack (RGB/VIDEO).
Connection to the RGB signal terminal
1. Input signals
Video signal
Horizontal sync signal
Vertical sync signal
Compound sync signal
Audio signal
2. Signal input jacks
1 Video input (red)
2 Video input (green)
3 Video input (blue)
4 N.C
5 N.C
6 Ground (red)
7 Ground (green)
8 Ground (blue)
22
Brightness signal
Color signal
Input
Output
Color signal
Ground
S-VIDEO input (mini DIN 4-pin)
Analog, 0.7V p-p, 75 Ω terminator (positive polarity)
TTL level (positive/negative polarity)
TTL level (positive/negative polarity)
TTL level
200mV rms, 20k Ω or less (max. 3.0V p-p)
Input
0~200mVrms,1k Ω
Output
9 N.C
10 Ground
11 N.C
12 DDC jack (Display Data Channel)
13 Horizontal sync signal/compound sync signal
14 Vertical sync signal
15 DDC jack (Display Data Channel)
1.0V p-p, 75 Ω terminator
0.286V p-p (burst signal), 75 Ω terminator
1.0V p-p, 75 Ω terminator
200mV rms, 20k Ω or less (max. 3.0V p-p)
0∼200mVrms,1k Ω
Brightness signal
Ground
(2) RCA jack input jack
D-sub 15-pin
shrink jack