Hitachi CP-X958W Manual De Instrucciones página 6

Handle the power cord with care.
•
Do not damage, cut, process or
strongly twist the power cord. Placing
heavy objects on the power cord, heating or
strongly pulling the power cord can result in
damage as well as fire or electrical shock.
• Pulling on the power cord
• Placing heavy objects on the power cord
• Damaging the cord
• Placing near heaters
•
Do not position the power
cord under the projector.
damage the power cord and cause fire or
electrical shock. Also, do not place a spread,
cover, etc., over the power cord because this
could result in the inadvertent placing of
heavy objects on the concealed power cord.
•
If the power cord is damaged
(exposed or broken core wires,
etc.), contact your dealer for
replacement; otherwise, fire or
electrical shock could result.
•
Make sure there is no dust, etc., on the power
plug and insert a knife blade to make sure that
there is no looseness.
Do not allow the laser beam to enter the
eyes.
•
This remote control is equipped with a
laser pointer and a laser beam is emitted
from the laser outlet. Do not look directly
into the laser beam outlet or direct the
laser beam at other people.
Vision can be impaired if the laser beam
enters the eyes. Especially pay attention if
children are present.
Warning
High temperatures are generated when
the lamp is lit, so do not place objects in
front of the lens.
This can
RADIAZIONI LASER
NON GUARDARE NEL RAGGIO LUCE
APPARECCHIO LASER DI CLASSE 2
RAYONNEMENT LASER
NE PAS REGARDER DANS
LE FAISCEAU APPAREIL
A LASER DE CLASSE 2
LASER-STRAHLUNG
NICHT IN DEN STRAHL
BLICKEN LASER KLASSE2
C A U T I O N
LASER RADIATION-
DO NOT STARE INTO BEAM
W A V E L E N G T H : 6 5 0 n m
M A X . O U T P U T : 1 m W
CLASS 2 LASER PRODUCT
MANUFACTURED
PLACE OF
A
MANUFACTURER:
MADE IN JAPAN
IEC60825-1:1993 + A1:1997
AVOID EXPOSURE-
LASER RADIATION IS
EMITTED FROM THIS
APERTURE
Laser beam outlet
5