Connection/Installation; Rm-P2580 System; System With Up To 8 Cameras - JVC TK-C1480B Manual De Instrucciones

CONNECTION/INSTALLATION

RM-P2580 System

System with up to 8 cameras

Camera
TK-C1480B
Camera 1
MACHINE ID:1
(Menu screen)
RX TERM: OFF
Camera
(switch)
TK-C1480B
Camera 2
MACHINE ID:2
(Menu screen)
RX TERM: OFF
(switch)
Camera
TK-C1480B
Camera 8
MACHINE ID:8
(Menu screen)
RX TERM: ON
(switch)
Remote Control Unit
This is the connected example of the TK-C1480BE.
When controlling with any system except the RM-P2580, execute proper settings using
switches and menu screens according to the systems used. (
MEMO
• When operating a system using the RM-P2580, several cameras (up to 8) can be con-
nected and used on one control signal cable. Consequently, an incorrect switch setting on
just a single camera will cause the entire system to work incorrectly.
• Confirm switch settings on the screen as follows.
q Confirm that the image from the camera to be checked
is displayed on the monitor.
w Turn OFF and then ON the AC 24 V power to the cam-
era to be checked.
e The camera begins the initial operation and characters
similar to those shown in the illustration on the right
appear on the monitor screen.
r Confirm that "DUPLEX" and "ID-□□" are displayed and
that the ID number is the correct number (the number
should be the same as the number of the VIDEO IN-
PUT terminal to which the camera is connected on the
rear panel of the RM-P2580).
t If wrong, set the camera ID again.
E-12
Control signal cable
Video signal cable
AC24V
Power
or
cable
DC12V
AC24V
or
DC12V
AC24V
or
DC12V
TO
CAMERA
TO CAMERA
TO CAMERA
RX RX + RX RX - TX TX + TX TX -
POWER
OFF
AC INPUT
RM-P2580
1 2
ON
ON
CAM SW
• • • • •
OUT
CAMERA
SW COM
DATA I / O
DATA I / O UNIT CAMERA
UNIT SERIAL-1
COM 1 2 3 4 5 6 7 8 COM 9/1 10/2 11/3 12/4 13/5 14/6 15/7 16/8 COM AUTO ALARM COM CAMERA SW COM SERIAL-1
COM COM 9/1 10/2 11/3 12/4 13/5 14/6 15/7 16/8 COM AUTO ALARM COM SW COM
VIDEO INPUT
VIDEO INPUT
1 2 3 4 5 6 7 8
MONITOR
MONITOR
OUTPUT
OUTPUT
1
3 4 5 6 7 8
1 2 3 4 5 6 7 8
VIDEO OUTPUT
VIDEO OUTPUT
(example showing camera ID as "05")
P R O T
"DUPLEX" should
be displayed.
Time lapse VCR
SR-L910
REC STOP/EJECT REC
OPERATE
CHECK VIDEO CASSETTE RECORDER
PAUSE/ OPE. LOCK
REVERSE STILL PLAY COUNT/ SHIFT/TRACKING RESET
CLOCK MENU /CANCEL
REW FF TIME TIMER SET/V.LOCK AL/PL
MODE REC RESET
VIDEO IN
SERIAL-2
SERIAL-2
MONITOR
MONITOR
MONITOR OUTPUT 2
OUTPUT
OUTPUT
2
MONITOR
OUTPUT 1
Page 14)
MONITOR screen
O C O L : D U P L E X
The number shown in the
□□ part of ID-□□
should be correct.
MONITOR
MONITOR
I D - 0 5