Controls, Connectors And Indicators - JVC TK-C1480B Manual De Instrucciones

INTRODUCTION

Controls, Connectors and Indicators

Lens mount
1
To attach the lens.
This is applicable to both C-mount lenses
and CS-mount lenses.
Backfocus adjustment ring
2
Adjusting the back focus during lens
installation.
When readjustment is required, loosen
the locking screw
counterclockwise and turn the back focus
adjustment ring
After the adjustment, tighten the locking
screw again.
3
[BF LOCK] Back focus locking screw
3
This serves to fix the back focus-adjusting
ring.
E-8
by turning it
3
.
2
Camera-mounting bracket
4
The bracket has been attached on the
bottom of the camera before shipment. It
can also be attached on the top
according to the circumstance.
To re-attach the bracket use the threaded
holes at the top, with the camera
mounting bracket locking screws
Camera-mounting screw hole (1/4
5
inch)
Use this hole when mounting
the camera onto a fixer, pan/
tilt unit, and the like. (Use a
screw shorter than 7 mm.)
Rotation-preventive hole
6
Make use of this rotation-preventive hole
to prevent any fall when mounting the
camera. Always make sure that the
camera is securely mounted.
Camera mounting bracket fixing screws
7
(×2: M2.6 × 6 mm)
Be sure to use a 6 mm long screw.
.
7
MAX.
7
mm