Troubleshooting; Pressure Does Not Build Up In The Appliance; Strong Pressure Fluctuations; Appliance Is Leaking - Kärcher K 4 Manual De Instrucciones

Troubleshooting

You can rectify minor faults yourself with
the help of the following overview.
If in doubt, please consult the authorized
customer service.
DANGER
Risk of electric shock.
 Prior to all work on the appliance,
switch off the appliance and pull the
power plug.
Appliance is not running
 Pull on the lever of the trigger gun; the
device will switch on.
 Check whether the voltage indicated on
the type plate corresponds to the volt-
age of the mains supply.
 Check the mains connection cable for
damages.
Appliance does not start, motor
hums
Voltage reduction due to weak mains sup-
ply or when using an extension cable.
 When switching on, first pull the lever of
the trigger gun and then switch the ap-
pliance switch to "I/ON".
Pressure does not build up in the
appliance
 Check setting at the spray lance.
 Check water supply for adequate deliv-
ery rate.
 Pull out the sieve in the water connec-
tion using flat-nose pliers and clean un-
der running water.
 Appliance ventilation: Switch the appli-
ance on with the high-pressure hose
detached and operate (max. 2 minutes)
until the water exits the high-pressure
connection without bubbles. Switch off
appliance and reconnect high-pressure
hose.

Strong pressure fluctuations

 Clean high-pressure nozzle: Remove
dirt and debris from the nozzle bore, us-
ing a needle and rinse through with wa-
ter from the front.
 Check water flow quantity.

Appliance is leaking

 Slight leakage from the appliance pump
is normal. If the leakage increases con-
tact the authorized customer service.
No detergent infeed
 Use spray lance with pressure regula-
tion (Vario Power).
Turn the spray lance to "Mix" position.
 Check the settings at the dosage regu-
lator for detergent.
 Check whether the Plug 'n' Clean deter-
gent bottle is placed into the detergent
connection facing down.
English 23