Measurements; Normal Measurement - AND 767F PRO Manual De Instrucciones

Measurements

Before measurement, read "Notes for Proper Measurement" on the next page.

Normal Measurement

1. Press the SET button to select a user from 1 to 4.
2. Place the cuff on the arm (preferably the left arm).
Sit quietly during measurement.
3. Press the START button.
All of the display segments are displayed.
Zero (0) is displayed blinking briefly.
The display changes, as indicated in the figure at the right,
as the measurement begins. The cuff starts to inflate.
It is normal for the cuff to feel very tight. A pressure bar
indicator is displayed, on the left edge of the display, during
the inflation.
Note: If you wish to stop inflation at any time, press the START button
again.
4. When inflation is complete, deflation starts automatically
and (heart mark) blinks, indicating that the measurement
is in progress. Once the pulse is detected, the mark blinks
with each pulse beat.
Note: If an appropriate pressure is not obtained, the device starts to inflate
again automatically.
To avoid re-inflation, see "Measurement with the Desired Systolic
Pressure" on the next page.
5. When the measurement is complete, the systolic and
diastolic pressure readings and pulse rate are displayed.
The cuff exhausts the remaining air and deflates
completely.
6. When not recording the measurement data, press the
or button.
7. Press the START button to turn the device off. After
one minute of non-operation, the device will turn off
automatically.
At hear level
Press
All of the display
segments displayed
Zero display
Starts inflation
Pressurizing
Measurement in
progress
Systolic pressure
Diastolic pressure
WHO classification
Pulse rate
Exhausts remaining
START
air automatically
E-11