Introduction; Important Warnings; Instructions For Installation - Baxtran MS Manual De Usuario

User's Guide

1. INTRODUCTION

Dear costumer:
We appreciate that you have chosen this product we assure you that you will get the maximum satisfaction of
the new acquisition for your business.
We suggest you to read carefully this manual and make sure to keep it at hand for later consultations.
Note: All the examples in this manual were performed in MS5 scale model.

2. IMPORTANT WARNINGS

1. In case you have a problem with the scale, first read the warranty conditions.
2. Do not open the scale on your own. Your warranty will be canceled.
3. "Never" press the keyboard with objects such as pencils, pens, knifes, etc.
4. Use a 220 V AC outlet exclusive for the scale avoiding overload or voltage variations.
5. "Never" wash the scale using a flow of water, this can damage the electronic components. For more infor-
mation read "Maintenance and cleaning" section. During the scale operation do not expose to dripping and
splashing.
6. Protect the scale from insects (mainly from roaches) they can seriously damage electronic components. Use
solid products against roaches.
7. Do not drop or hit the scale with the product to be weighted because as time goes by it will damage the
weight sensor.
8. Do not use solvents or detergents for cleaning only use damp rag.
9. Do not place fans or heaters directed towards the scale.
10. Do not place the scale where there is a lot of moisture and/or dust.
11. Only autorized and qualified personnel should check and repair your scale.

3. INSTRUCTIONS FOR INSTALLATION

1. Unpack the scale and check to see if it is damaged. If it is, report it immediately to your authorized distribu-
tor.
2. Place the scale where there is not any movement or vibration, make sure it is leveled adequately checking
that the level, tighten or loosen the leveling base untill the bubble is within the black circle. Finally tighten
the nut look of each of the bases.
3. Connect the AC/DC power supply's cable (if you use it) to 220V a.c. outlet.
4. Turn the scale on and after the countdown sequence your scale will display zeros and will be ready to use.
IMPORTANT NOTE: If your scale displays "HELP" after you followed the previous steps and after the initial
countdown, it means that caused irreversible damage in its operation. Call your authorized distributor, is posi-
ble that the scale displays "HELP" when you turn it on with weight on the plate, when this happens, remove the
weight and turn the scale off and turn it on.
28
Check weight scale Model MS