Calibration Counter; Other Important Messages That Appear On The Scale; Maintenance And Cleaning - Baxtran MS Manual De Usuario

Check weight scale
A. CALIBRATION COUNTER:
1. Turn the scale on.
2. Press
during the countdown. At the end of the countdown
the view finder will display:
B. COUNTER OF TIMES THAT THE INTERNAL CONFIGURA-
TION HAS BEEN CHANGED:
1. Turn the scale on.
2. Press
keys during the initial countdown. At the end of the
countdown the view finder will display:
In any of the two cases, to get to the normal operation mode, just turn off the scale and then turn it on again.
Your scale leaves the factory with the next readings:

Calibration counter

Configuration counter CF.001
7. OTHER IMPORTANT MESSAGES THAT APPEAR IN THE SCALE
This message indicates that a weight that exceeds the maximum
capacity has been placed on the scale. To correct this, simply
remove the over weight.
This message appears in two different situations:
A. When the scale is turned on with an excessive weight on the
plate (over 30 kilograms, 66'14 pounds or 1058'22 ounces for a
MS30 model). To correct this situation remove the weight that is
on the scale, turn off the scale and then turn it on again.
B. When the scale was handled roughly and/or got hitted during
the shipment, which caused irreversible damages in this opera-
tion. In this case call your authorized distributor.
This message indicates a negative weight, this could happen if
you lift or remove the pan or you turn on the scale with anything
over the pan and you take off it after the count-down.

9. MAINTENANCE AND CLEANING

■ One of the greatest advantages of purchasing this scale model is that it requires minimum maintenance and
it is very simple to keep it in favorable conditions.
■ Do not use a flow of water to clean your scale. Use a damp rag and clean each of this components daily:
plate, tower, keyborad.
■ To remove oil and greasy substances, use a dry and clean rag, rubbing the dirty area several times.
■ Do not use detergents nor corrsive liquids while cleaning.
Model MS
CA.001
User's Guide
35