Channel Selection - Emerson LD195EM8 7 Manual Del Usuario

[] Channel Selection
Selectchannels by using [CH.• / V] or[the Numberbuttons].
Use [CH.• /V] or [the Number buttons] to select the
memorized channels.
or
, v j/
or
.7.L) ._ _9.L.
EN_
Using [the Number buttons]
-When selecting analog channel 12
- When selecting digital channel 12-1
ENT
• Be sure to press [-lENT.] before entering the minor
channel number.
• Press [CH. RECALL _%] to return to the previously
viewed channel.
• When you select a channel larger than 100, press
[+100] first. Then use [the Number buttons] to press
the lower 2-digit numbers.
• Only [the Number buttons] can be used to select the
non-memorized channels.
About digital TV broadcasting:
With its high definition broadcast, digital broadcasting
far surpasses analog broadcasting in both its picture
and sound quality.
What is the minor channel?
By using high compression technology, digital
broadcasting offers a service that enables multiple
signals to send simultaneously. Therefore, you can
select more than one program per major channel since
digital broadcasting technology distinguishes between
multiple channels broadcast by a single network.
NTSC (analog mode) [Air Time] ATSC (digital mode)
18:00
18:30
19:00
19:30
20:00
20:30
major channel minor channel
_I_ : change automatically
_> : change manually by using [CH.A/V]
Although, you cannot watch the high definition TV
(HDTV) program, the unit converts the HDTV signal
down to the standard definition TV signal.
Note:
•"NO SIGNAL"will appear on the TVscreen after the minor
channel broadcast is over.
[] Volume Adjustment
Thissection describes h owto adjustthevolume.
Themutefunction,whichturnsthe sound offand on,isalsodescribed.
Use [VOL. _ / _] to adjust the audio volume.
or v_.)
VOLUME 20
Illlll ..........
• The volume bar will be displayed at the bottom of the
TV screen when adjusting the volume.
• The volume bar will automatically disappear in a few
seconds.
Press [MUTE o_] to turn offand on the sound.
i <i
MUTE
MUTE
20
IIIIII ..........
• "MUTE" is displayed on the TV screen.
Press [MUTE _] again or use [VO/._/_] to recover
the original volume.
i............
i<>
[] Switching Each Input Mode
Youcaneasilyswitch with the remotecontrol t o theDTV(ATSC) andTV
(NTSC) or toaccess e xternaldevices whentheyareconnected to theunit.
Press [INPUT] repeatedly to cycle through the input
modes.
'i !3!!
<:, .....
iiE:,,
ii <2>
ii . .....
INPUT
• To use the video or S-video input jack on the unit,
select "VIDEO1 ".
• To use the component video input jacks on the unit,
select "VIDEO2".
• To use the PC input jack on the unit, select"PC".
Note:
•When you switch the analog mode to the digital mode,
it may take a while until the digital channel selection is
completed. "NOW SCANNING"is displayed while switching
the modes.
<2:
<:
EN