Emerson LD195EM8 7 Manual Del Usuario página 28

[] PC Settinqs
ThisfunctionletsyouadjustthePCscreen position, c lock andphaseduring
PCinput.
1 Press [SETUP] to display the main menu.
2 Use [Cursor • /V] to select"PC SETTING",
then press [ENTER].
e.g.) PC mode
or
- TVSETUP -
CHANNELSETUP
V-CHIP SETUP
LANGUAGE [ENGLISH]
CAPTION [OFF]
RACK LIGHT [BRIGHT]
COLOR TEMR [NORMAL]
PC SETTING
CLOCK, PHASE
Use [Cursor •/V] to select an item,
then use [Cursor </1_] to adjust the "CLOCK"setting
to stabilize the PC screen and the "Phase" setting to
improve the clarity of the PC screen.
Cursor _1 Cursor I_
CLOCK
to decrease setting value to increase setting value
PHASE
Press [SETUP] to exit.
3 Adjust the setting.
AUTO ADJUSTMENT
Use [Cursor •IV] to select "AUTO ADJUSTMENT",
then press [ENTER].
or
- PC SETTING-
_"AUTO ADJUSTMENT
HORIZONTALPosmoN [ 15]
VERTICAL POSITION [ -15]
CLOCK [ -5]
PHASE [ O]
Note:
• Adjust the "PHASE"setting after the "CLOCK"setting has
been properly adjusted.
• Youmay not obtain an appropriate screen with auto
adjustment for some signals. In this case, adjust the settings
manually,
• Thesetting range of the horizontal/vertical position is +30,
but the limit value differs depending on PCinput signaL
• The horizontal/vertical position, clock and phase of
the PC screen are automatically adjusted in a few
seconds.
HORIZONTAL POSITION, VERTICAL POSITION
Use [Cursor •IV] to select an item,
then use [Cursor </1_] to adjust the PC screen position.
Cursor _1 Cursor I_
HORIZONTAL
POSITION to move PC screen left to move PC screen right
VERTICAL
POSITION
to move PC screen down
to move PC screen up
EN